Estes Mix & Match 60 #2007

002007 – Mix-N-Match 60

$45.99 $16.10

Parts for 3 rockets! Decals for many more! So much fun!

Description

Enough parts to build 3 colorful rockets! 2 huge self-stick decal sheets! Super fun colors! Let your creative juices run wild decorating these rockets!

What’s Included :

50 parts – All BT-60 size
3 nose cones and nose cone inserts
6 pre-colored (1.64 in. diameter) body tubes
3 body tube connecters
3 fin can units
12 fins – 3 different styles (NOTE: DO NOT mix fin styles or colors)
3 launch lugs and clear reinforcements
3 shock cords
3 pre-assembled parachutes
2 self-stick decal sheets

WHAT YOU NEED TO LAUNCH (sold separately): Estes Porta-Pad II Launch Pad with a 1/8 inch launch rod and Electron Beam Launch Controller, Estes model rocket engines, starters and recovery wadding. Four 1.5V high quality AA alkaline batteries are also required for launch controller (not included).

Additional information

Recommended EnginesB4-2, B6-2, C6-3, C6-5
Recovery System3x 15 in. (28.1 cm) Parachute
Estimated Assembly Time1 Hour (painting and glue drying time not included)
Fin MaterialsPlastic
Decal TypeSelf-stick
Launch SystemPorta-Pad II and Electron Beam Launch Controller
Launch Rod Size1/8″
Age RecommendationEstes model rocketry is recommended for boys and girls ages 10+ with adult supervision for those under 12, and rocketeers of all ages.

Photo Gallery

Build History

  • 2/26/2020 – Took pictures of package and contents. Scanned contents. Cemented fin cans of all 3 models. Marked body tubes 1-1/2″ from aft end and then made intentions of where launch lug pins would be located. Using an awl punched holes for pin locations on body tubes of all 3 models and cemented launch lugs to body tubes. Marked each red tube coupler in the middle and glued it into the lower body tube up to the mark. Glued the upper body tube over the tube coupler and flush with the lower body tube. Made a copy of page 1 and cut out the shock cord mounts for each rocket.
  • 2/27/2020 – Glued shock cord to each shock cord mount and then glued it into the forward end of the body tube. Cemented the nose cone base into each nose cone. Applied self-adhesive decals to each model using instruction as a guide for placement. This completes construction of 3 Estes Mix & Match 60 #2007 model rockets.

Flight Data

  • Date – Flight Data